Reply to topic

Issues with fish finder and wiring

2 post(s), 2 voice(s)
Author Message
MichaelSmith
Anon128
Post(s):5

Hello,

I had a little bit of an issue the last time my friend and I went out in our Oasis. It was our 2nd time using our Garmin FF, first time it worked flawlessly. The second time we went out, it initially kept giving an error that the transducer was not connected. We tried disconnecting and reconnecting the plug on the back several times, it did not help so we beached the kayak and I wiggled the wire connection inside the kayak, where the wire from the transducer connects to the wire that plugs directly into the FF. We got an image and thought “great, good to go!” went out on the water, and while it could tell the depth, there was static all over the screen. We proceeded fishing minus the ability to see fish for the day.
Then today I went to check the wires, I had connected them using the little “press to burst” crimps in the Hobie FF kit and added some electrical tape to attempt to help and secure the wires together further. It looked OK to me, but obviously it wasn’t connected well enough. I went ahead and cut the wires and just tied them together manually by hand for a second and checked the FF, but obviously out of the water I can’t tell if the image is good. I still see some static, but I’m unsure if it’s because it’s out of the water. Also I have the transducer in a “bed” of duct seal. If I didn’t seal the duct seal around the transducer well and water got under the transducer between it and the kayak would that matter? Does the transducer need to be making contact directly to the bottom of the kayak or is it OK for there to be duct seal UNDER the transducer between it and the kayak?
Basically what I’m asking is, has anyone run in to this? Does anyone have any tips/tricks on better ways to connect the two wires, or anything it sounds like I might be doing wrong?

Please help

I didn’t find the right solution from the internet.

References:
https://bigsalty.com/community/viewtopic.php?pi...
Motion graphics animation studio

Thank you

liltrouble
Small
Post(s):289

What unit do you have? Sometimes if it isn’t recognizing the ducer it could be it needs a software update. The downloads are available on Garmin’s website if it is one that takes updates.

When you bed a transom mount transducer in a hull, you need to make sure that the medium you are mounting it in is ai/rbubble free and has nothing between the hull and the ducer. No air, etc.

Also, if you run some transducers out of water they generate enough heat that they can damage the ducer. That will give you the “no transducer detected” message.

Go to Airmar’s site and look at the transducer information. They make most of Garmin’s transducers. You can see some basic info there on transducer care and feeding.